Last edited by Malasida
Monday, May 18, 2020 | History

5 edition of A study of leeside flow field heat transfer on shuttle orbiter configurations found in the catalog.

A study of leeside flow field heat transfer on shuttle orbiter configurations

Leroy C. Baranowski

A study of leeside flow field heat transfer on shuttle orbiter configurations

by Leroy C. Baranowski

  • 274 Want to read
  • 36 Currently reading

Published by National Aeronautics and Space Administration, Langley Research Center in Hampton, Va .
Written in English

    Subjects:
  • Space shuttles

  • Edition Notes

    StatementLeroy C. Baranowski and H.W. Kipp
    SeriesNASA contractor report -- 172361
    ContributionsKipp, H. W, Langley Research Center, McDonnell Douglas Astronautics Company-St. Louis
    The Physical Object
    FormatMicroform
    Pagination1 v.
    ID Numbers
    Open LibraryOL14928145M

    In the present study, the local heat transfer of an obliquely impinging air jet issuing from a rectangular nozzle is examined. Typical flow regions for such a jet are depicted in Fig. ments were performed using a ×50 mm rectangular nozzle with an exit jet velocity ranging between and m/s. Launch Delays. The first delay of the Challenger mission was due to a weather front expected to move into the area, bringing rain and cold y a mission wasn't postponed until inclement weather actually entered the area, but the Vice President was expected to be present for the launch and NASA officials wanted to avoid the necessity of the Vice President's having to make an.

    Full text of "NASA Technical Reports Server (NTRS) Computational Aerothermodynamic Design Issues for Hypersonic Vehicles" See other formats.   The ball-park figure for space itself is Zero and you treat the sun separately and since it is so much hotter than objects such as the space shuttle, you just use the solar radiation flux (w/m^2 iirc). For an object in orbit around the earth, you'd probably treat .

    SPACE SHUTTLE ORBITAL DOCKING SYSTEM. Background. Since its first flight in , NASA has used the space shuttle for human transport, the construction of the International Space Station (ISS), and to research the effects of space on the human body. One of the keys to the success of the Space Shuttle Program is the Space Shuttle Mission. The Space Shuttle: Roles, Missions and Accomplishments. New York: Wiley, This comprehensive book about the Space Shuttle describes its origins, operations, and explorations, as well as discussing weightlessness, exploration, and outposts. The book also contains a Space Shuttle mission log, glossary, and bibliography. Hoversten, Paul.


Share this book
You might also like
Report of the Librarian of Congress ....

Report of the Librarian of Congress ....

In-car entertainment.

In-car entertainment.

The container industry.

The container industry.

Edinburgh

Edinburgh

Food Safety After Nuclear Accidents (Food)

Food Safety After Nuclear Accidents (Food)

Great firsts

Great firsts

Getting absent workers back on the job

Getting absent workers back on the job

Quick QL machine language

Quick QL machine language

Antitrust Law (Antitrust Law)

Antitrust Law (Antitrust Law)

New directions in InP solar cell research

New directions in InP solar cell research

impact of institutional investors on corporate governance, takeovers, and the capital markets

impact of institutional investors on corporate governance, takeovers, and the capital markets

Sword master at Naval Academy.

Sword master at Naval Academy.

A study of leeside flow field heat transfer on shuttle orbiter configurations by Leroy C. Baranowski Download PDF EPUB FB2

The item A study of leeside flow field heat transfer on shuttle orbiter configurations, Leroy C. Baranowski and H.W. Kipp represents a specific, individual, material embodiment of a distinct intellectual or artistic creation found in Indiana State Library. Get this from a library.

A study of leeside flow field heat transfer on shuttle orbiter configurations. [Leroy C Baranowski; H W Kipp; Langley Research Center. On the computation of the transonic perturbation flow field around two- and three-dimensional oscillating wings.

A survey of leeside flow and heat transfer on delta planform configurations. Effects of surface temperature and Reynolds number on heat transfer to the Shuttle Orbiter leeward fuselage. American Institute of Aeronautics and Astronautics Sunrise Valley Drive, Suite Reston, VA Full text of "Aerodynamic design of the space shuttle orbiter" See other formats AERODYNAMIC DESIGN OF THE SPACE SHUTTLE ORBITER by W.E.

Bornemann Manager, Space Shuttle Aerodynamics Rockwell International Corporation Space Systems Group Lakewood Boulevard Downey, CA T.E. Surber Supervisor, Orbiter Aerodyanmics and Rockwell International. FLOW-FIELD SURVEYS ON THE WINDWARD SIDE OF THE NASA A SPACE SHUTTLE ORBITER AT 31° ANGLE OF ATTACK AND MACH 20 IN HELIUM George C.

Ashby, Jr., and Vernon T. Helms III Langley Research Center SUMMARY Pitot-pressure and flow-angle distributions in the windward flow field of the NASA A space shuttle orbiter configuration and surface. study, separation of the space shuttle orbiter from a carrier vehicle was shown to be feasible for a range of dynamic-pressure and flight-path-angle conditions.

By using an autopilot, the vehicle attitudes were held constant which ensured separation. Carrier-vehicle engine thrust, landing gear, and spoilers provide. Shuttle Infrared Leeside Temperature Sensing. the infrared camera system is mounted in such a way that it rotates to view the orbiter leeside surfaces through either of two windows-one offering a view of the orbiter fuselage and the other a view of the left wing.

The camera is. (ii) The Shuttle's enters the atmosphere at such a high velocity that the air under its path does not have an opportunity to disperse and is compressed. Compressing a gas causes it to heat. The radiant heat from the air that has been heated (by the compression) begins to.

The evaluated average heat transfer coefficients α f are listed in Table 3. By using equation Q = α f ⋅Δt⋅A, the total heat transfer rates Q on the plate are obtained and listed in Table 3. Comparison of heat transfer coefficient predicted by the optimal formalized equations with.

space shuttle main engines. pogo suppression system. space shuttle main engine controllers. malfunction detection. orbiter hydraulic systems. mps thrust vector control. helium, oxidizer and fuel flow sequence.

orbiter/external tank separation system. inch disconnect. external tank separation system. orbiter umbilical doors. orbital. Finite-Element Reentry Heat-Transfer Analysis of Space Shuttle Orbiter Author: Ko, William L., Robert D.

Quinn, and Leslie Gong Subject: NASA TP Keywords: Heat-transfer analysis, Reentry heating, Space Shuttle orbiter, Space t ransportation system data Created Date: 7/2/ AM. Experimental assessment of a computer program used in space shuttle orbiter entry heating analyses (NASA technical memorandum) Unknown Binding – January 1, by William L Wells (Author) See all formats and editions Hide other formats and editions.

Enter your mobile number or email address below and we'll send you a link to download the Author: William L Wells. Convective heat transfer enhancement can be achieved by generating secondary flow structures that are added to the main flow to intensify the fluid exchange between hot and cold regions.

One method involves the use of vortex generators to produce streamwise and transverse vortices superimposed to the main flow. This study presents numerical computation results of laminar convection heat.

The leeside flow structure was examined in detail, and grid resolution studies and comparison to the available experimental data for surface pressure and heat transfer were carried out.

View Show. nduring missions STS and STS, NASA used the Space Shuttle Orbiter’s heat shield to perform a hypersonic boundary layer transition (BLT) experiment. 1,2. Within this dome, the infrared camera system is mounted in such a way that it rotates to view the orbiter leeside surfaces through either of two windows-one offering a view of the orbiter fuselage and the other a view of the left wing.

The camera is sensitive to heat sources from to 1, F. Before the Project Apollo Moon landing inNASA began studies of Space Shuttle designs as early as October The early studies were denoted "Phase A", and in June"Phase B", which were more detailed and specific.

The primary intended use of the Space Shuttle was supporting the future space station, ferrying a minimum crew of four and ab pounds (9, kg) of cargo, and. During ground operations (checkout, prelaunch, and post landing), orbiter heat rejection is provided by the GSE heat exchanger in the Freon coolant loops through ground system cooling.

From lift-off to an altitude of less thanfeet-approximately seconds-thermal lag is used. Heat transfer and equilibrium temperature of a sphere in a supersonic rarefied gas flow.

Authors; and Yu. Osipov, “Study of flow and heat transfer of a rarefied gas in a plane supersonic nozzle”, Inzh. fiz. zh.,5, no. 4, Study of the Heat Transfer Coefficient of Particles in a Flow under Unsteady Conditions [in Russian.

Orbiter Aero Data Book Table Lookup Aircraft Equations of Motion Nominal Aerodynamic F&M Simultaneously acquired global heat transfer mappings we re obtained for a majority of the configurations disturbance in the leeside flow field, resulting in increased heating on the side of the fuselage and the.Space Shuttle Glider Educational Product Grades 5–12 Teachers & National Aeronautics and Students Space Administration USA EPHQ Your Space Shuttle glider is a centimeters scale model of the U.S.

Space Shuttle orbiter. The airplane-like orbiter can remain in Earth orbit for up to two weeks at a time. It normally carries a.Problem A model of the space shuttle is shown in Figure 8. Thrust is provided by the two solid rocket boosters and the three liquid-fuelled orbiter engines.

The centre of mass of the fully loaded An air flow traveling at Mach over a wedge of an unknown angle generates a 32 ° oblique shock wave.